Filter
Top Products
Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 767
ip route-cache <address>
Use the ip route-cache command to enable fast-cache switching on the interface. Use the no form of this
command to disable fast-cache switching and return to process switching mode.
Syntax Description
No subcommands.
Default Values
By default, fast-cache switching is enabled on all Ethernet and virtual Frame Relay sub-interfaces. IP
route-cache is enabled for all virtual PPP interfaces.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 2.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Functional Notes
Fast switching allows an IP interface to provide optimum performance when processing IP traffic.
Usage Examples
The following example enables fast switching on the ATM sub-interface 1.1:
(config)#interface atm 1.1
(config-atm 1.1)#ip route-cache
Using Network Address Translation (NAT) or the AOS firewall capabilities on an interface
requires process switching mode (using the no ip route-cache command).