Filter
Top Products
Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 383
event-history priority [error | fatal | info | notice | warning]
Use the event-history priority command to set the threshold for events stored in the event history. All
events with the specified priority or higher will be kept for viewing in the local event log. The event log
may be displayed using the show event-history command. Use the no form of this command to keep
specified priorities from being logged.
Syntax Description
Sets the minimum priority threshold for logging messages to the event history. The following priorities are
available (ranking from lowest to highest):
error Logs events with error and fatal priorities.
fatal Logs only events with a fatal priority.
info Logs all events.
notice Logs events with notice, warning, error, and fatal priorities.
warning Logs events with warning, error, and fatal priorities.
Default Values
By default, no event messages are logged to the event history.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
The event history provides useful information regarding the status of the system and individual port states.
Use the event history as a troubleshooting tool when identifying system issues. The following is a sample
event history log.
Router#show event-history
Using 526 bytes
2002.07.12 15:34:01 T1.t1 1/1 Yellow
2002.07.12 15:34:01 INTERFACE_STATUS.t1 1/1 changed state to down.
2002.07.12 15:34:02 T1.t1 1/1 No Alarms
2002.07.12 15:34:02 INTERFACE_STATUS.t1 1/1 changed state to up.
2002.07.12 15:34:03 INTERFACE_STATUS.eth 0/1 changed state to up.
2002.07.12 15:34:10 OPERATING_SYSTEM Warm Start
2002.07.12 15:34:12 PPP.NEGOTIATION LCP up
2002.07.12 15:34:12 PPP.NEGOTIATION IPCP up