Filter
Top Products
Command Reference Guide Frame Relay Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 885
dial-backup redial-delay <seconds>
Use the dial-backup redial-delay command to configure the delay after an unsuccessful call until the call
will be re-tried. For more detailed information on Frame Relay dial-backup functionality, refer to the
Functional Notes and Technology Review sections of the command dial-backup call-mode [answer |
answer-always | originate | originate-answer | originate-answer-always] on page 876.
Syntax Description
<seconds> Specifies the delay in seconds between attempting to re-dial a failed backup
attempt. Range: 10 to 3600.
Default Values
By default, dial-backup redial-delay is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example configures a redial delay of 25 seconds on this endpoint:
(config)#interface frame-relay 1.16
(config-fr 1.16)#dial-backup redial-delay 25