Filter
Top Products
Command Reference Guide Frame Relay Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 843
FRAME RELAY INTERFACE CONFIG COMMAND SET
To activate the Frame Relay Interface Configuration mode, enter the interface frame-relay command at
the Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface frame-relay 1
(config-fr 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 844
encapsulation frame-relay ietf on page 845
fair-queue <threshold> on page 846
frame-relay commands begin on page 847
hold-queue <queue size> out on page 859
max-reserved-bandwidth <percent> on page 860
qos-policy out <mapname> on page 861
snmp trap on page 863
snmp trap link-status on page 864