Filter
Top Products
Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 186
show frame-relay fragment [frame-relay <port.sublink>]
Use the show frame-relay fragment command to display FRF.12 statistics for Frame Relay sublinks
enabling FRF.12 fragmentation.
Syntax Description
frame-relay
<port.sublink> Optional. Displays detailed FRF.12 statistics for the specified Frame Relay
sublink (if FRF.12 is enabled on that sublink).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 6.1 Command was introduced.
Usage Examples
The following are sample outputs from various
show frame-relay fragment
commands:
>enable
#
show frame-relay fragment
interface dlci frag_size rx_frag tx_frag dropped_frag
fr 1.1 17 100 46 48 0
fr 1.2 18 200 42 21 0
>enable
#show frame-relay fragment frame-relay 1.1
DLCI = 17 FRAGMENT SIZE = 100
rx frag. pkts 46 tx frag. pkts 48
rx frag. bytes 4598 tx frag. bytes 4724
rx non-frag. pkts 18 tx non-frag. pkts 28
rx non-frag. bytes 1228 tx non-frag. bytes 1960
rx assembled pkts 23 tx pre-fragment pkts 34
rx assembled bytes 5478 tx pre-fragment bytes 6324
dropped reassembling pkts 0 dropped fragmenting pkts 0
rx out-of-sequence fragments 0
rx unexpected beginning fragment 0