Filter
Top Products
Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 308
show tcp info [realtime] <control block>
Use the show tcp info command to display Transmission Control Protocol (TCP) control block
information in the AOS. This information is for troubleshooting and debug purposes only. For more
detailed information, you can optionally specify a particular TCP control block. When a particular TCP
control block is specified, the system provides additional information regarding crypto map settings that
the show tcp info command does not display.
Syntax Description
realtime Displays full-screen output in real time. See the Functional Notes below for more
information.
<control block> Optional.
Specifies a particular TCP control block for more detailed information.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 4.1 Command was introduced.
Release 10.1 The real time display option was introduced.
Function Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
terminal length <text> on page
318
).
Usage Examples
The following is a sample from the
show tcp info
command:
>enable
#
show tcp info
TCP TCB Entries