Filter
Top Products
Command Reference Guide T1 Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 697
T1 INTERFACE CONFIGURATION COMMAND SET
To activate the T1 Interface Configuration mode, enter the interface t1 command at the Global
Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface t1 1/1
(config-t1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through | through <interface id>] on page 698
coding [ami | b8zs] on page 699
fdl [ansi | att | none] on page 700
framing [d4 | esf] on page 701
lbo [long <-22.5, -15, -7.5, 0> | short <0-655>] on page 702
loopback commands begin on page 703
remote-alarm [rai] on page 706
remote-loopback on page 707
show test-pattern on page 708
snmp trap line-status on page 709
snmp trap link-status on page 710
snmp trap threshold-reached on page 711
tdm-group <group number> timeslots <1-24> speed [56 | 64] on page 712
test-pattern [clear | insert | ones | p215 | p220 | p511 | qrss | zeros] on page 713