Filter
Top Products
Media Gateway Configuration
Issue 5 October 2007 73
The following table lists the fields in the MG Config tab of the Module Configuration dialog box
and their descriptions.
Table 22: MG Config Parameters
Field Description
QOS Control The source of QoS control. This parameter can only be changed via
the CLI. Possible values are:
● Local - The processor is using the local QoS parameters. The
802 priority and DSCP fields can be configured.
● Remote - The processor is receiving QoS parameters from a
remote Media Gateway. All QoS parameters are read only.
DSCP Priority based on a technology by which packets are marked in the IP
header Type of Service (ToS) byte as belonging to a specific class.
Possible values are 0 - 63.
802 Priority Priority based on the 802.1p standard, which assigns rights and
privileges to users on a telephony network. Possible values are 0 - 7.
Operational Status Operational Status of the Media Gateway. Possible values are:
● OK - Media Gateway is operating properly.
● Fatal - Media Gateway is down.
Fault Messages A list of fault messages.