Barco LED-PRO Projector User Manual


 
14 LED-PRO • User’s Guide
2. Hardware Orientation
LED-PRO Front Panel
^Äçìí=íÜÉ=ildl
The LOGO button can be thought of as an additional input video source which can be
selected and transitioned in the normal manner. The button allows you to capture a still
frame from any input (1, 2, 3 or SD/HD), and store that image in flash memory. When
selected, the LOGO button lights and the output displays either a stored image (typically a
company logo) or black.
To capture a LOGO (control panel method):
1. Press and hold the desired input button
2. Press LOGO.
The system temporarily freezes the output, captures a frame from the selected
input, and stores the frame in non-volatile memory. A “progress bar” and related
messages will be shown on the display during the capture process.
To capture a LOGO (menu method):
1. Manually freeze the desired image (SETUP > Expert Mode > Freeze > On).
2. Manually capture the logo (SETUP > Expert Mode > Logo > Capture Logo).
Please note the following important points regarding the LOGO:
The LOGO can be de-selected by pressing one of the other four input sources.
When LOGO is selected, the PAN & ZOOM button is not operational.
When no logo is stored internally, the output displays black, and the Status Menu
indicates "Internal Black" as the format.
When the LOGO is selected and there is a logo stored, the Status Menu indicates
"LOGO" as the input format.
If a LOGO is stored in flash memory, the image remains through a power cycle.
The LOGO can be overwritten by capturing a new image.
If you perform a factory reset, the LOGO is cleared from flash memory.
You can delete the LOGO manually from flash memory using the Logo Menu. In
Chapter 4, refer to the “Logo” section on page 86 for menu details.
LOGO