Filter
Top Products
LED-PRO • User’s Guide 37
4. Operation
Using the Status Menu
pí~íìë=jÉåì=aÉëÅêáéíáçå
The Status Menu provides information about the currently selected system input (as
determined by the input buttons) and the selected output. If the input is changed, the fields
change accordingly. Other pertinent changes that you make within the menu system are
shown, once you return to the Status Menu.
Figure 4-11. Status Menu Fields
Following are descriptions of each variable field:
• <type>
Specifies the type of input signal being processed. Choices include NTSC/PAL/
SECAM, SDI, HD-SDI, RGB, YPbPr, or DVI.
• <in_format>
Indicates the current input video format in the following form:
Hact x Vact @ Vr Hz
S 1280x1024@60
Please note:
~ If a “saved” user input configuration is used for the current input (as
saved with the Save Config or Save System State functions), the field
shows the name of the user input configuration — instead of the format.
In this case, to view the format’s parameters, use the Input Menu
(SETUP > Expert Mode > Input).
~ If the format itself is displayed, the input has not been saved.
~ If the currently selected input does not have a valid input signal, the
message "Invalid Signal" is shown.
• <genl_mode+src>
Indicates the current “Lock to Source” mode and type (if locked), as set on the
Lock to Source Menu (SETUP > Expert Mode > Output > Lock to Source).
Refer to the “Lock to Source
” section on page 83 for details.
Choices include:
~ Freerun — Not locked, freerun timing
~ HV Lock, Input — horizontal and vertical lock to input video
~ V Lock, Input — vertical lock to input video
If the unit is set for a particular “Lock to Source” mode and type, but that source is
missing (or lock can not be achieved), the unit periodically attempts to lock. While
IN: <type>
<in_format>
OUT <gen1_mode+src>
<wall status>