Filter
Top Products
LED-PRO • User’s Guide 57
4. Operation
Using the Setup Wizard
3. Press SEL to launch the wizard and display the Setup Wizard Start Message.
Figure 4-32. Setup Wizard Start Message
4. Press SEL to continue. During this interval, LED-PRO will detect the tiles, query
the tiles and count the number of tiles. The larger the LED wall, the longer the
interval.
~ If no errors are detected, at the conclusion of this “detection” interval, the
Wall Information Menu is displayed as shown below.
~ If errors were detected, please continue with step 5 below.
Figure 4-33. Wizard - Wall Information Menu (sample)
Following are descriptions of each menu field:
~ Type — displays the type of LED tile detected.
~ Count — displays the number of LED tiles detected.
~ Fiber Tx ID — displays the address of the Fiberlink transmitter, if used.
~ Fiber Rx ID — displays the address of the Fiberlink receiver, if used.
If no errors were detected during the “detection” interval, continue with step 6.
5. If errors were found during the “detection” interval, the Wall Information Menu
will not be shown. Instead, one of four possible messages will be shown:
~ If no tiles were detected, you will be asked to “Check cabling and
power.” When complete, press SEL to continue.
~ If the Fiberlink Transmitter is detected but the Receiver is not, you will
be asked to “Check cabling and power.” During this interval, a white
test pattern will appear. Press SEL to continue, and then verify that wall
is powered up.
~ If both the Fiberlink Transmitter and Receiver are detected, but no tiles
are detected, you will be asked to “Check cabling and power.” During
this interval, a white test pattern will appear. Press SEL to continue, and
then verify that wall is powered up.
LED-PRO FULL WIZARD
Connect all power
and video cables
Press <SEL> to start
Note
An error message will be shown if the LED wall is not
connected.
WALL INFORMATION
> Type: ILite 3
Count: 20
Fiber Tx ID 0002
Fiber Rx ID 0003
Next