Filter
Top Products
LED-PRO • User’s Guide 51
4. Operation
Using the Setup Menu
opOPO
From the Setup Menu, select RS232 to display the RS232 Menu, which enables you to set
the baud rate for the rear panel RS-232 connector.
Figure 4-23. RS232 Menu (sample)
To set the RS-232 connector’s baud rate:
1. On the Baud line, press SEL. The navigation cursor (>) changes to the edit
cursor (#).
2. Choose the desired baud rate with the knob, and “accept” it by pressing SEL.
Choices include 19200, 38400, 57600 and 115200. Note that the selected Baud
rate is not updated until the SEL button is pressed.
bñéÉêí=jçÇÉ
From the Setup Menu, select Expert Mode to display the Expert Mode Menu, which
provides extensive “advanced” system setup functions. Refer to the “Using the Expert
Mode Menu” section on page 66 for full instructions.
p~îÉ=póëíÉã=pí~íÉ
From the Setup Menu, select Save System State to perform the following functions:
• Save all input, output and system settings in non-volatile memory — so they can
be restored at power up.
• Save a specific input so that it will be acquired and selected at power up. By
default, input 1 is selected at bootup and after a factory reset.
RS232
> Baud 19200
Note
Most operations will be performed at 19200.
Note
If LED-PRO is placed in Remote mode and Director Toolset
is connected, the Director Toolset may update the RS232
Menu with a different setting, such as 115200.
Note
When the Status Menu is next selected, the message “Last
Saved [1, 2, 3 or 4]” appears on line 2, depending upon which
input is selected.
Note
If you do not perform the “Save System State” function,
some system information may not be restored upon the next
system power up.