Barco LED-PRO Projector User Manual


 
34 LED-PRO • User’s Guide
4. Operation
Quick Function Reference
Enable or disable the LED boost mode Boost Mode 103
Enable or disable the LED creative mode Creative Mode
103
Enable or disable the LED OSD (on screen display) LED OSD
102
Enable or disable the LED tile mode Tile Mode
103
Enable or disable the raster box Raster Box
94
Get information (status) about the current input and output Using the Status Menu
36
Get information on LED wall and fiber communications LED Information
82
Lock or unlock the front panel Lock Front Panel
91
Pan (tilt) image vertically Pan V
96
Pan image horizontally Pan H
96
Program EDID Programming EDID
53
Recall a “global” preset (or "View") Recall
49
Recall a “local” preset from memory Recall Preset
97
Recall an input configuration Recall Config
78
Reset “local” preset settings to default values Reset
97
Reset an input configuration Reset Config
78
Reset output configuration Reset Config
84
Reset to factory default Factory Reset
51
Run the Input Wizard Using the Input Wizard
62
Run the Setup Wizard Using the Setup Wizard
56
Save “local” preset Save Preset
97
Save a “global” preset (or "View") Save
50
Save a custom input format Custom In Format
72
Save all system, input and output settings Save System State
51
Save an input configuration Save Config
107
Save output configuration Save Config
84
Select (configure) a custom input format Custom In Format
72
Select an input signal type Type
72
Select colorspace Colorspace
72
Select sync, de-interlace, pulldown comp and sync slice Processing
77
Set “lock to source” parameters Lock to Source
83
Set Diagnostic Port RS-232 parameters Diagnostic RS232
88
Set Ethernet parameters (mode, DHCP, IP address) Ethernet
89
Table 4-1. LED-PRO Quick Function Reference Table (Continued)
How to: Use the Following: Page