Barco LED-PRO Projector User Manual


 
LED-PRO • User’s Guide 19
3. Installation
Rack-Mount Installation
o~ÅâJjçìåí=fåëí~ää~íáçå
LED-PRO units are designed to be rack mounted and are supplied with front rack-mount
hardware. Please note the following important points:
Rear rack-mount brackets are available as a kit, and are recommended for use
when units are mounted in transit cases.
When rack mounting the unit, remember that the maximum ambient operating
temperature for the unit is 40 degrees C.
Leave sufficient front and rear space to make sure that the airflow through the fan
and vent holes is not restricted.
When installing equipment into a rack, distribute the units evenly to prevent
hazardous conditions that may be created by uneven weight distribution.
Connect the unit only to a properly rated supply circuit.
Reliable grounding (earthing) of rack-mounted equipment should be maintained.
Rack mount the unit from the front rack ears using four rack screws (not supplied).
Rack threads may be metric or otherwise — depending upon the rack type.
Install the lower of the two mounting holes first.
mçïÉê=fåëí~ää~íáçå
Use the following steps to install power to the LED-PRO:
1. Connect an AC power cord to the AC Power Connector on the rear of the LED-
PRO, and then to an AC outlet.
2. Connect AC Power cords (or AC adapters) to all peripheral equipment, such as
video sources and PCs. Please note:
~ Connect each unit only to a properly rated supply circuit.
~ Reliable grounding of rack-mounted equipment should be maintained.
3. Ensure that your LED wall is properly assembled, and that all power cords are
distributed and connected to all tiles — in the proper sequence. Refer to your
specific LED tile’s “User’s Guide” for details.