Filter
Top Products
5) Detach the transfer roller and the static eliminator.
6) Detach the transfer guide.
7) While butting the two heaters against the transfer guide as shown in Figure 4-326, fix
them in place using two screws e; then, fix the harness using two harness bands r
(front, rear).
8) Fix the harness with two SK binders t (front, rear) in place, and insert it into the
transfer guide.
Figure 4-326
Caution:
When fixing the harness in place, make sure that the cap portions of the terminal
are alternated as shown in Figure 4-327; if bundled in parallel, the harness will
come into contact with the transfer roller.
Figure 4-327
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
4-45