Filter
Top Products
2. Routing the Blank Shutter Cable
Figure 10-224
3. Positioning the Solenoid for the Primary Charging Roller
Loosen the two screws used to fix the solenoid e in place, and move the solenoid in
the direction of B so that the
R in Figure 10-225 is 5.5 ±0.2 mm when the joint q is
butted against a of the solenoid support plate w.
Caution:
Be sure to make the adjustment whenever you have replaced the solenoid.
Figure 10-225
10-22
CHAPTER 10 TROUBLESHOOTING
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Attach the spring to
the outside of the
sides shutter.
Slide shutter (rear)
Wind 3.5 times.
Slide shutter (front)
a
= 5.5 ± 0.2
2
1
3