Filter
Top Products
B. Installation to the Copier
Caution:
This model may not be available for sale in some areas.
Caution:
Keep the following in mind when installing the RDD to the copier:
1. This Accessory is to be installed by a qualified personal.
2. Make sure the copier has been properly installed before starting the work.
3. Keep the copier’s power cord disconnected during the work.
4. Be sure to use the appropriate screws (length, diameter).
5. Make sure the computer in the service station has been properly loaded with the
RDD’s settings data.
1) Remove the two screws w to detach the RDD’s top cover q.
Figure 8-702
2) Connect the Power Supply Unit’s connector e to the RDD’s connector r as shown.
Figure 8-703
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
8-27
CHAPTER 8 INSTALLATION
w
q
w
r
e