Filter
Top Products
15) Call up the service station, and request the RDD’s initial settings. (LED 4 @2 (red)
starts to flash upon receipt.)
Fig. 8-717
16) Call up the service station to check if the initial settings have been successfully
made; if the attempt has failed, reset the RAM once again starting with step 11)
through 13).
Important:
You must confirm that the RDD’s settings are correct by calling the service station.
17) Check that you can place a telephone call from the RDD to the computer in the
service station.
Press the push switch 4 !7. LED6 @3 (red) should come on; it will go out when
transmission ends successfully, or will start to flash if transmission fails.
Retransmission is executed in response to a press on the push switch 4 !7 while
LED6 @3 is flashing.
Transmission is canceled in response to a press on the push switch 1 @4 while LED6
@3 is flashing.
Fig. 8-718
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
8-36
CHAPTER 8 INSTALLATION
LED1 LED2 LED3
2
1
LED5
LED6
LED4
IC6
SW1
SW4
SW3
6
1
BAT1
CN4
1
2
CN3 CN2
@2
SW2
LED1 LED2 LED3
2
1
LED5
LED6
LED4
IC6
SW1
SW4
SW3
6
1
BAT1
CN4
1
2
CN3 CN2
SW2
@4
!7
@3