Filter
Top Products
Canon MultiPASS C50 Hardware Manual ENGLISH
4-11Chapter 4 Sending Faxes
2. Use the numeric buttons to dial the other party’s fax number.
Ex:
1 2
ABC
3
DEF
4 5
JKLGHI
6
MNO
7 8
TUVPQRS
9
WXYZ
0
TEL=9p1503753798
½ Use one of the dialling methods described on page 4-7.
½ If you must first dial a digit to get an outside line (e.g. ”9”), press the
(REDIAL)/PAUSE button to add a pause after that digit, as shown in the
example above.
3. Press START/COPY.
½ The MultiPASS C50 then begins scanning the document into memory, and
dials the number:
TX
After a few seconds, the display shows the following messages:
TX/RX NO. 0001
(Transaction number for the fax)
SCANNING P.001
(Number of pages it has scanned)
CALLING
TEL=9p1503753798
(The number you dialled)
The display continues to show these displays while the fax is sending.
½ When the MultiPASS C50 finishes sending the fax, the display shows the
TRANSMITTING OK message:
TRANSMITTING OK
½ The transaction number (TX/RX NO.) is a unique number the MultiPASS
C50 assigns to the document you are sending or receiving, and is used to
identify the document in transaction reports.
½ If an error occurs during sending, the MultiPASS C50 will print out an error
report. If this happens, try sending the fax again. See ”Faxing Problems” on
page 8-12 for details about errors.