Filter
Top Products
Canon MultiPASS C50 Hardware Manual ENGLISH
5-5Chapter 5 Receiving Faxes
½ If the call is from a fax machine, the MultiPASS C50 receives the fax
automatically.
½ If the call is a telephone call, the MultiPASS C50 rings to alert you to pick up
the handset. If you do not pick up the handset within 22 seconds, the
MultiPASS C50 stops ringing, checks again to make sure the call is not from a
fax machine, then hangs up. (You can use the MultiPASS Desktop Manager to
change the 22 seconds, increasing the amount of time the MultiPASS C50
rings before it hangs up.)
½ Not all fax machines are capable of sending a FAX TONE. For those cases
you can set your MultiPASS C50 to switch to receive mode automatically and
start receiving the document. If no document comes in, it disconnects after
approximately 35 seconds. See the MultiPASS Desktop Manager User’s Guide
for instructions on setting this switch.
½ If the MultiPASS C50 runs out of paper or if its BJ cartridge runs out of ink
while the unit is receiving a fax, it receives the remainder of the fax into its
memory.
½ To stop receiving a fax before it is complete, press the
(STOP) button.
½ If the ALARM light flashes, make sure the error is corrected and then press
the (STOP) button. See ”The Alarm light comes on.…” under ”Printing
Problems” on page 8-19.