Filter
Top Products
A-4
Installation Guide for Cisco Unity Release 5.x with IBM Lotus Domino (Without Failover)
OL-13599-01
Appendix A Voice Cards and PIMG Units
Intel Dialogic D/120JCT-LS and D/120JCT-Euro
To Set the D/41JCT-LS and D/41JCT-Euro Card Switches and Jumpers
Step 1 Set the rotary switch (SW30) to a unique value for each card.
Each Intel Dialogic card in the Cisco Unity server or expansion chassis must have a unique value,
starting with 1 and continuing in sequence on subsequent cards. For example, set the rotary switch on
the first three voice cards as shown below. This is also the order in which you install the cards in the
Cisco
Unity server or expansion chassis.
Step 2 Set the SW4 hook-state switch to Off.
Step 3 Settings for jumpers JP1 and JP2 are as follows:
Jumper JP1 is reserved. Do not install a shunt across the pins of JP1.
Set jumper JP2 according to the number of D/41JCT-LS or D/41JCT-EURO cards in the server or
expansion chassis:
Intel Dialogic D/120JCT-LS and D/120JCT-Euro
The D/120JCT-LS and D/120JCT-Euro voice cards each provide 12 channels of call-processing and
loop-start interfaces in a single PCI slot. The D/120JCT-LS is used in North America, South America,
and Japan, and the D/120JCT-Euro is used in Europe, Australia, and New Zealand. The cards connect 12
analog loop-start phone lines to 12 onboard call-processing resources by using RJ-14 connectors.
We recommend using the newer Revision 2 Universal (3.3Vdc or 5Vdc dual voltage) PCI versions of the
Intel Dialogic D/120JCT-LS and the D/120JCT-Euro cards, rather than the older single-bus voltage
(5Vdc) versions of the cards.
Note that older Revision 1 LS cards are still supported for use with Cisco Unity version 4.0(x), but they
cannot be ordered for new Cisco Unity version 4.0(x) installations. In addition, the older LS cards can
be used only when they are appropriate for the available slots in the Cisco
Unity server or expansion
chassis.
If you are installing cards that have H.100 connectors, you need an H.100 cable that has at least as many
connectors as you have cards (you must connect all cards by using a single cable) but no more than five
extra connectors.
You may need to attach or remove the slot retainer bracket that ships with the card, depending on the
mechanical configuration of the Cisco
Unity server or expansion chassis.
55486
First card
Second card
Third card
1
2
3
One card
Unterminated (the default configuration).
Two or more cards
Install the shunt on the JP2 jumper of a card to terminate the CT bus (H.100
signal) at that card. Terminate only the first and last cards on the CT bus cable.