Filter
Top Products
3-5
Installation Guide for Cisco Unity Release 5.x with IBM Lotus Domino (Without Failover)
OL-13599-01
Chapter 3 Setting Up the Hardware
Attaching Peripheral Devices and Making Connections from the Phone System
• If the Cisco Unity system is using voice cards to integrate with a circuit-switched phone system,
place the server near the phone system.
• If the Cisco Unity system is using PIMG units to integrate with a circuit-switched phone system,
place the PIMG units near the phone system and near a network connection.
Caution Do not attach the network cable to the server until you have installed the Microsoft service
packs and updates recommended for use with Cisco
Unity. The Cisco Unity installation guide
alerts you when to install the service packs and updates, and when to connect to the network
later in the installation process.
Step 2 Attach any supported peripheral devices to the server. Follow the manufacturer installation and test
instructions.
Step 3 If Cisco Unity is integrated with a circuit-switched phone system: Make the necessary connections from
the phone system. See the applicable integration guide.
Cisco Unity integration guides are available at
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_installation_and_configuration_g
uides_list.html.
For pinout information, see the “Voice Cards and PIMG Units” appendix.
Step 4 If Cisco Unity is integrated with a circuit-switched phone system, you are installing the Cisco Unity
system outside the United States, and the server contains voice cards that came with a ferrite clamp:
Attach the clamp around the analog phone lines as close to the server as possible.