Filter
Top Products
A-10
Installation Guide for Cisco Unity Release 5.x with IBM Lotus Domino (Without Failover)
OL-13599-01
Appendix A Voice Cards and PIMG Units
Intel Dialogic D/240PCI-T1
Step 2 Settings for jumpers JP2 through JP5 depend on the number of D/240PCI-T1 voice cards in the
Cisco
Unity server:
Figure A-11 D/240PCI-T1 Jumpers JP2 Through JP 5: Off
Figure A-12 D/240PCI-T1 Jumpers JP2 Through JP 5: On
Step 3 On jumpers JP6 and JP7, install shunts on the top two pins (1 and 2).
Software Settings
For a D/240PCI-T1 voice card, set the protocol manually after the Cisco Unity Setup program is
finished.
To Set the D/240PCI-T1 Protocol
Step 1 On the Windows Start menu, click Settings > Control Panel > Phone and Modem Options.
Step 2 In the Phone and Modem Options dialog box, click the Advanced tab.
Step 3 Click Dialogic Generation 2 Service Provider for NT.
Step 4 Click Configure.
Step 5 In the Dialogic TSP Configuration dialog box, click Advanced.
Step 6 In the Configuration Service dialog box, click the Digital Protocols tab.
Step 7 In the Currently Assigned Protocols list, click DtiB1 Undefined Protocol.
One card
Set jumpers JP2 through JP5 to Off (Figure A-11) on
the card.
Two cards
Set jumpers JP2 through JP5 to On (Figure A-12) on
both cards.
Three or more cards
Set jumpers JP2 through JP5 to On (Figure A-12) on the first and last cards.
Set jumpers JP2 through JP5 to Off (Figure A-11) on all other cards.
55490
Setting
JP2
JP3 JP4 JP5
55491
Setting
JP2 JP3 JP4 JP5
55489
Setting
JP6
JP7