Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-5. Disassembly, Reassembly and Lubrication
3-31 CL-S700/CL-S703/CL-S700R
3-5-17. Disassembling the “Unit, Frame”
To remove the “Unit, Frame”, refer to Step 9 in "3-5-9. Each Unit on the “Unit, Mechanism"
1. Remove the “SA, Sensor U” (Fixed type) [9-7].
1) Remove 1 screw (PH (SW+PW), M3x6) [9-34] and remove the “SA, Sensor U” (Fixed type)
[9-7].
2. Remove the “SA, Sensor Bottom” (Fixed type) [9-18].
1) Remove 1 screw (No. 0, FHT (BT#1), M2x8) [9-36] and detach the “SA, Sensor Bottom”
(Fixed type) [9-18].
3. Remove the Paper Guide [9-8].
1) While pushing the Paper Guide Spring [9-17], remove it from the hook of the Paper Guide
[9-8]. Then, remove the Friction Cork [9-16] and the Paper Guide [9-8].
4. Remove the “Unit, Motor” [9-38].
1) On the left lower of the “Unit, Mechanism”, remove 3 screws (PH (SW+PW), M3x5) [9-32]
and detach the Motor block and “Belt, Motor Drive” [9-12].
2) Disconnect the “SA, PF MTR Cable” [9-30] from the Motor block, remove 2 screws (PH
(SW+PW), M3x6) [9-33], and detach the ”Bracket, Motor” [9-6] from the “Unit, Motor”
[9-38].
Note on reassembling:
• Adjust the belt tension of the “Belt, Motor Drive” [9-12].
Refer to “3-6-2. Belt Tension Adjustment”.
5. Remove the “Unit, Roller Platen” [9-1].
1) Remove 1 screw (BH, M3x5K) [9-34] and detach the “Cover, Pulley” [9-9].
2) Push the lever of the “Plate, Tension” [9-28] downward and remove the “Belt, Platen Drive”
[9-2], then detach the “Unit, Roller Platen” [9-1] by lifting it upwardly.
Note: For easier disassembly procedure, refer to “3-5-2. Unit, Roller Platen.
6. Remove the “SA 1, Drive Shaft” [9-13].
1) Remove 2 screws (HSS (KCP), M3x5) [9-25] and detach the “Pulley, Drive Shaft” [9-24]
and “Bushing, Motor Drive” [9-23].
2) Pull out the “SA 1, Drive Shaft” [9-13] to the left and remove the 2 “Bearing, Drive Shaft”
[9-14].
7. Remove the Idle Gear Sub Assembly [9-15].
1) Disengage 1 E-ring (E-Ring, 3) [9-36] and remove the Idle Gear Sub Assembly [9-15].
8. Remove the “Plate, Peel” [9-11].
1) Remove 1 screw (PH (SW+PW), M3x6) [9-33] and detach the “Plate, Peel” [9-11].