Filter
Top Products
Chapter 3 Disassembly and Maintenance
3-6. Adjustments
CL-S700/CL-S703/CL-S700R 3-52
3-6-2. Belt Tension Adjustment
Belt tension adjustment is necessary in the following case.
- When the “Unit, Motor” is replaced.
1. Remove the screw “B” and loosely tighten the Motor block with 2 screws “A”.
2. Push the left side of the Motor block with the tip of the spring gauge as shown in the figure.
3. Push it so that the spring gauge reads the following value.
600 to 1000 gf.
4. Tighten the Motor block with 2 screws “A” and the screw “B”.
[Spring Gauge]
* Use Max. 2000gf gauge.
[Left side view of the “Unit, Mechanism”]
A
Belt, Motor Drive
Motor Block
B
A
Spring Gauge