Filter
Top Products
7-32 Advanced Features
www.dell.com | support.dell.com
4 Change the Emulation setting from Auto detect to ANSI or VT100/220.
This setting should be the same as the setting you selected for the Console
Redirection field on the server.
When you click Terminal Setup, you should see a setting for the number of rows and
columns.
5 Change the number of rows from 24 to 25 and leave the number of columns at 80. If
you do not have these settings, then this is an indication that you must upgrade your
terminal emulation software.
Rebooting the System
Console redirection is designed to yield control of the serial ports to the operating system,
which allows serial debugging and redirection of the operating system to function correctly
without interference from the system BIOS.
To use console redirection to shut down a system and troubleshoot it or to change small
computer system interface (SCSI) BIOS configurations, perform the following steps:
1 Restart the system. See “Configuring Special Keys,” found later in this document, for
a recommendation on how to do this.
2 When the system begins to reboot, use console redirection to watch and interact with
the system during the power-on self-test (POST). While the system is booting, you
can do the following:
• Enter the system setup program.
• Enter the SCSI setup menus.
Configuring Special Keys
Console redirection uses ANSI or VT100/220 terminal emulation, which are limited to basic
ASCII characters. There are no function keys, arrow keys, or control keys in this character
set. However, most BIOS software requires the use of function keys and control keys for
ordinary functions. You can emulate a function key or control key by using a special key
sequence, called an escape sequence, to represent a specific key.