Filter
Top Products
Troubleshooting 9-3
I am getting event errors for
Services for Macintosh.
Services for Macintosh are
bound to the onboard network
interface card (NIC) by
default. If this NIC has been
disabled, binding errors will
occur.
Bind the AppleTalk protocol
to an enabled NIC. See
“AppleTalk Protocol Adapter
Binding.”
I configured the system using
Kick-Start and I cannot get to
the PowerVault NAS Manager
using a browser.
The system may not be
connected to the network, or
the network settings may not
be correct.
Check to make sure that the
system is connected to the
network. If it is, then check to
make sure that you entered a
correct IP address in the
Kick-Start Application Menu.
If the problem persists, use
the serial port as described in
the “Configuring Your System
Using a Serial Connection” to
access the PowerVault NAS
Manager and check that the
configuration settings were
correct.
From a Macintosh client,
users cannot modify or delete
a file that a Windows client
has accessed.
The time is not properly
synchronized between clients
and the system.
Make sure that clients have
their time synchronized
within ten minutes relative to
the time zone.
I rebooted through the
PowerVault NAS Manager
from a Macintosh client.
Several minutes have passed
and the page has not
refreshed.
PowerVault NAS Manager
does not automatically refresh
the screen when the NAS
appliance has finished
rebooting.
Close Internet Explorer and
then reconnect to the
PowerVault NAS Manager.
I just created a new volume on
my system but cannot see the
volume on Windows Explorer
through Terminal Services.
Terminal Services will not
update to show a new volume
during the session in which it
was created.
Exit from Terminal Services
and reconnect. The volume
should now be visible.
Table 9-1. Troubleshooting Issues
Issue Possible cause Resolution