Filter
Top Products
MIL-3000FTX Series of FastPort Print Servers 10-6
• FPFILTER Configuration-->Enable FPFILTER: Enables host software services. Default:
Enabled.
-->
Auxiliary ports: Specifies the auxiliary ports for the parallel and serial
port printing. Default is
0 for each port.
Note:
The number of auxiliary ports to configure depends on the number of serial and
parallel ports on the FastPort.
• LPD Configuration: Enables BSD-type LPD print services and its options. Default: All are
Enabled.
•
Restricted Hosts: -->Subnets: Limits access to FastPort. Only hosts in the selected
subnet can access FastPort. Default for “Subnet” and “Mask” is
0.0.0.0.
-->
Allowed IP Addresses: Limits access to FastPort. Only the hosts with
the IP addresses can access FastPort. Default for all four fields is
0.0.0.0.
10.4.2Novell Config.
There are a series of choices that can be selected to configure FastPort for a
Novell network, including:
Figure 10-10. Novell Config. Selections (Windows ‘95)
From Novell Config., selections include:
• IPX Config. -->IPX SAP Name: Changes the name used by the device in service
messages on the IPX network. This name displays in Map 1 of the Discovery
Application node. Default:
FPXXXXXX, where “XXXXXX” is a the last six digits
of the MAC address.
-->
IPX SAP Interval: Configuring the SAP internal of the device (numbers
are between 1-6). Default:
1.
-->
IPX Traps-->Enable IPX Traps: When enabled, the software sends
“traps” to a designated system. Default:
Enabled. For more
information on traps, refer to “Traps” on page 2 and “IPX Trap
Hosts” (next selection).
-->
IPX Trap Hosts: Designates to the system where traps will
be sent. Default for both “IPX Trap Host 1” and “IPX Trap Host
2” are all zeros.
-->
IPX Enabled: Enables/disables IPX protocol. Default: Enabled.
•
NDS Config. -->Enable NDS: Enables/disables NetWare Directory Services. Default:
Enabled.
-->
Preferred DS Tree: Sets the “tree” where FastPort’s server and print
queues are defined. The name entered must be a valid “Tree” or “Context.”
The field is blank by default.