Digi MIL-3000FTX Printer User Manual


 
MIL-3000FTX Series of FastPort Print Servers 3-4
7. Choose a local name to call this printer.
8. When prompted, choose to print a test page. A test page is printed out
on the FastPort-connected printer.
The Windows system is now configured to print to FastPort.
3.1.5 Printing From NetBIOS-supported DOS Workstation
NetBIOS workstations support the DOS-level Net commands for locating
and redirecting local ports to shared printers. These DOS-level commands
include net view and net use.
3.1.5.1 Net View
net view: This command shows all devices within a workgroup
communicating on the network with the same networking protocol as
the client workstation.
net view /workgroup:<wgname>: This command shows all devices
within the workgroup <wgname> communicating with the same
protocol as the workstation.
net view \\FP042384: This command shows all the shared
resources on a Digi print server with hardware address
00:40:c8:04:23:84. Net view displays the following:
Shared resources at FP042384
Sharename
Type Comment
PARALLEL1 Print parallel-port #1 (ON-LINE)
PARALLEL2 Print parallel-port #2 (OFF-LINE)
SERIAL1 Print serial-port #1 (ON-LINE)
SERIAL2 Print serial-port #2 (ON-LINE)
The command was completed successfully. Print Server Name
FP042384 and share names PARALLEL1, are user configurable from the
FastManage or NBMON tool (both described in the chapter 6).
3.1.5.2 Net Use
NET USE LPT1: \\FP042384\SERIAL1—This redirects printing
from the LPT1 port to the serial 1 port on FastPort.
NET USE LPT1: /D—This deletes the redirect (that is, stops the
redirection to FastPort).