Digi MIL-3000FTX Printer User Manual


 
MIL-3000FTX Series of FastPort Print Servers 10-7
-->Preferred DS Context: Sets the “context” where FastPort’s server/
queues are defined. The name entered must be a valid “Tree” or “Context.
The field is blank by default.
Print Server Config.-->Queue Scan Rate: Sets the rate (times per second) that
FastPort scans the Novell queue for print jobs (valid numbers are between 1-
6). Default:
1.
-->
Frame Type: Selects NetWare’s frame type. Default: Autosensing.
-->
Configuration Server: Is the server where FastPort’s bindery
configuration file resides. The field blank by default.
-->
Notification: Enabling this parameter allows FastPort to send status to
users on the Notify list Default:
Disabled.
10.4.3General Config.
There are a series of choices that can be selected to configure FastPort for a
general network, including:
Community Strings: Sets SNMP community strings. Default for “Get Community
String” is
public. Default for “Set Community String” is private.
Flash Config. -->Allow download: Allow/disallow the upgrade of the Firmware. Default:
Allow.
10.4.4Ethertalk Config.
There are a series of choices that can be select to configure FastPort for a
Ethertalk network, including:
Figure 10-11. Ethertalk Config. Selections
From Ethertalk Config., selections include:
General Config.--> Zone Name: Logical group where FastPort exists.
-->
Enable Ethertalk: Enables/disables the Ethertalk protocol. Default:
Disabled.
-->
Ethertalk Phase: Sets the compatibility level of the Appletalk network
system. Default:
Phase 2.
Parallel Printer Setup-->Printer 1: This selection sets printer 1 port’s parameters.
-->
Printer 2 (optional): Sets printer 2 port’s parameters.
-->
Printer 3 (optional): Sets printer 3 port’s parameters.
Note:
The number of printers to configure depends on the number of parallel ports on the
FastPort.