Filter
Top Products
MIL-3000FTX Series of FastPort Print Servers 8-5
• Save Maps On Exit: If this parameter is selected, the software saves
the Map when Discovery Application is exited. Checked by default.
• Save Parameters On Exit: If selected, this option saves preferences
when Discovery is exited. Checked by default.
• Refresh every: This selection “refreshes” the Map every <n>
seconds. Default: 60 seconds.
• Discover: This selection “re-discovers” hosts every <n> seconds.
Default: 90 seconds.
• Dead: This selection is the number of attempts the software makes
before marking the node as “dead.” Default: 2.
• Wait: This selection signifies the amount of time the software waits for
a reply from a node. Default: 1 second.
• Default Map: This selection will enter the name of the default Map
file: map.map.
• Map File: This selection will enter the path for the Map files. Default:
c:\fm.
• Hosts File: This selection enters the path for the host file. Default:
C:\ETC.
• Bootptab File Path: This selection enters the path for the bootptab
file. Default: C:\FM.
• Allow To Edit “Hosts” File: If selected, Discovery updates the
“hosts” file if a new host file is discovered. Checked by default.
• D
efault: Initialize all the parameters to default values.
• Save Options: Saves all changes to the issnmp.ini file.
• Cancel: Cancels the changes.
8.2.2.2Discovery Parameters
The “Discovery Parameters” menu (Figure 8-4) configures the parameters
used for the discovery nodes (Chapter 9). The following section gives
information about the discovery.
• Enable IP: When selected, this enables IP protocol. If not selected,
FastManage will not perform any SNMP over IP operation. Checked by
default.