Digi MIL-3000FTX Printer User Manual


 
MIL-3000FTX Series of FastPort Print Servers C-2
Resetting FastPort’s NVRAM of to factory defaults
Choosing a primary NetWare server
Enabling/disabling protocols (e.g., TCP/IP, EtherTalk, etc.)
Customizing LPD
C.1.3 Requirements
A MIL-3XXX FastPort print server with firmware release 4.5.x (and
above) installed.
NetWare file server with the PC logged into the server.
NetWare enabled (i.e., NetWare drivers are loaded).
Supervisor access to an object is required for some features.
C.1.4 Setup
1. Create a directory for the software (e.g., type md Digi and press
[Enter]. Where Digi is the directory’s name).
2. From the utility driver, copy the file ACT.EXE onto the recently created
directory. From C:\Digi>, type copy a:\ and press [Enter].
C.1.5 Navigating in ACT
From the appropriate directory (e.g., c:\Digi), enter ACT.
1. Type ACT and press [Enter].
2. Select a device or a menu option by:
a. Using arrow keys, highlight an item and press [Enter].
b. Use a hot key, usually the first letter in the menu option.
3. To exit out of a menu or option, press [Esc].
4. Highlight the designated field and press [Enter]. To leave ACT, select
the Exit menu.
C.2 Advanced Configuration Menu in ACT
The Advanced Configuration menu has five major submenus:
NetWare Configuration: Controls NetWare-specific print server
parameters.