Filter
Top Products
MIL-3000FTX Series of FastPort Print Servers E-5
• Before Reset
• After Reset Delay
The IP address can be found in the Setup Defaults file.
Note:
Apple products were only designed to print to postscript printers. The following
suggestions may or may not work on the workstation
E.2.5 Troubleshooting Setup on AppleTalk
On test page, please verify:
• Front panel switch D1 is up (off)
• The Power and the Link LEDs are solid
• The Sys and the Net LEDs are blinking
Note:
If the link LED does not light, try different port or another cable. If connecting directly—
Peer-to-Peer to a PC/Workstation—then use a swap/cross-over cable with a 1-3, 2-6
pinout.
• AppleTalk is enabled
• FastPort's default Phase II is what the AppleTalk network is running
• FastPort is showing up in the AppleTalk Zone—especially if when
using a router
• For bi-directional printer, enable “bi-directional printing” on
the FastPort or disable “Advanced Functionality/Bi-
directional” printing on the printer. To do this:
a. Change it through the printer's software
b. Hook up the printer direct
c. Print one job or change on printer's keypad
• The parallel/serial port on the printer is set to the FastPort’s active port
(or the printer’s port is autosensing)
• “Printer in chooser” option is set to Sense or Always
• When using a serial printer:
a. Make sure the serial port is enabled in the Chooser
b. Verify the parallel/serial port is set to the FastPort’s active port (or
the printer’s port is autosensing)