Filter
Top Products
MIL-3000FTX Series of FastPort Print Servers H-2
H.4 Discovery Application Messages
Table H-4: Discovery Application Messages
H.5 Ping Application Message
Table H-5: Ping Application Message
H.6 BOOTP Server Application Messages
Table H-6: BOOTP Server Application Messages
The address contains one field with value
more than 255. Not all fields are defined
A valid IP address is in the form of a.b.c.d, where a.b.c.d can
vary from 0 to 255. For example: 193.25.86.214
Host name appears as blanks Create hosts file with a vertical list of host names:
“hostname space IP” or <host name> <IP address>
Message Solution
IP, IPX, and NetBIOS Discovery are disabled. For
Discovery to work, at least one of them should be
enabled. Please update SNMP section, IP/IPX entries of
issnmp.ini file. Discovery will exit now
Valid Values are:
IP=YES or IP=NO
IPX=YES or IPX=NO,
NetBIOS=Yes or NetBIOS=No
Unable to open file (bitmap file) The FastManage installation may be bad. Reinstall
Unable to copy palette for the bitmap The FastManage installation may be bad. Reinstall
Unable to create bitmap from file DIB The FastManage installation may be bad. Reinstall
No such pathway or drive is not ready Restart Windows
Message Solution
IP is disabled in the file issnmp.ini. IP needs to be enabled
for this application to run. This application will exit now
Enable IP discovery in the Discovery
Application to enabled IP
Problem Cause Solution
Please retry when there is a BOOTPtab
file
No Bootfile found Enter BOOTPtab file and retry
IP is disabled in the file issnmp.ini. For
this application to run, enabled IP
IP discovery disabled in the Discovery
Application
Enable IP Discovery in the
Discovery Application to
enabled IP
Error to read packet This message comes when a bad BOOTP
packet is received
Retry. If the problem still
persists, reset the device
The address should contain only HEX
digits. i.e., 0-9, and A-F/(a-f)
Validation for MAC address Enter a valid MAC address
Hardware address is not specified. So
this entry cannot be saved
This message appears during the
operation “Add entry to BOOTPtab file”
Enter Host name address in the
user entry form
IP address is not specified. So this entry
cannot be save
This message appears during the
operation “Add entry to BOOTPtab file”
Enter IP Address in the user
entry form
This is not a valid hardware address User input invalid MAC address A valid hardware address is a
12 digit HEX number. For
example: 01.23.45.67.89.AB