Filter
Top Products
214 The Control Panel
This operation changes according to the Auto Cut settings.
Note:
This setting is available for roll paper only.
INTERFACE
You can select an interface to receive your print data. When you
select AUTO, the printer automatically switches between interfaces,
depending on which one is receiving data first. When you select
USB, IEEE1394, or OPTIONAL I/F CARD, only the selected interface
receives your print data. If no more print job is received, the
printer returns to an idle state after 10 seconds or more.
CODE PAGE
You can select a code page: PC437 (extended graphics) or PC850
(multilingual).
Paper Source Print Page Line Printer’s Operation
Roll Auto Cut On On Prints a page line on the right
side only, and cuts paper
automatically after the print
job.
Roll Auto Cut On Off Does not print any page lines,
and cuts paper automatically
after the print job.
Roll Auto Cut Off On Prints page lines on the right
side and below the data, but
does not cut paper
automatically after the print
job.
Roll Auto Cut Off Off Does not print any page lines
and does not cut paper.