Filter
Top Products
Viewing the Configuration
The current configuration can be viewed using the front panel buttons. The View-only mode
prevents inadvertent changes to the current configuration. View-only mode also provides a
way to mute outputs (see Muting and Unmuting Outputs on page 39).
View the current configuration as follows:
1. Press the Esc button to clear any front panel button indications that may be lit.
2. Press and release the View button. All of the buttons light for outputs that are not tied.
3. Select the desired input or output whose ties you wish to view by pressing the input or
output buttons.
NOTES:
• When you enter View-only mode, the output buttons light for all outputs without
ties. Likewise, when you press an output button for which there are no ties, the
output buttons light for all outputs without ties.
• To see all ties of the current configuration, press and release each input and
output button, one at a time.
• After 30 seconds of front panel inactivity, View-only mode automatically
deselects.
Example 4: Viewing ties
In the following example, we view the ties in the current configuration. The steps show the
front panel indications that result from your actions.
NOTE: This example assumes that you have performed example 1 on page 27,
example 2 on page 28, and example 3 on page 29.
1. Clear all selections: Press and release the Esc button.
2. Select View-only mode: Press and release the View button. The View button lights.
C O N T R O L
PRESET
ENTER
ESCVIEW
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
OUTPUTS
Until you select an input, only the buttons for untied outputs light.
Press the View button.
The button lights.
FOX Matrix 3200 and 7200 Switchers • Operation 31