Filter
Top Products
Serial-port-connected firmware upload
1
Figure 40. Extron Firmware Loader Window
1. Select the FOX matrix switcher and click
File
> New Firmware for Selected
Devices. The Choose Firmware File dialog box appears (see figure 41).
2
2
Figure 41. Choose Firmware File Window
2. Navigate to and select the new firmware file. Click
Open
. The Choose Firmware File
window closes.
3. In the Firmware Loader window, click
Begin
(see figure 42).
The Total Progress and Progress status bars show the upload progress. The firmware
upload may take several minutes. Once the status bars have progressed from 0% to
100%, and Status is listed as Complete, the firmware loader utility resets the switcher.
3
Figure 42. Firmware Loader Screen
4. Click
Exit
to close the Firmware Loader.
NOTE: The firmware loader increases the baud rate to 115,200. The
firmware loader may not return the serial port to its earlier baud rate, making
communications with the switcher impossible. If you cannot communicate with the
switcher after a firmware upload, change the baud rate on your computer and, if
necessary, see Selecting the Rear Panel Remote Port Protocol and Baud
Rate on page 42.
FOX Matrix 3200 and 7200 Switchers • Matrix Software 83