Filter
Top Products
Software Operation via a Serial Port
The serial ports are independent of one another. A front panel Configuration port connection
and a rear panel Remote RS‑232/RS‑422 port connection can be active at the same time.
The default serial port protocol of both ports is as follows:
• 9600 baud • No parity • 8 data bits
• 1 stop bit • No flow control
The serial ports can be configured to operate at the 9600, 19200, 38400, or 115200 baud
rate but Extron recommends leaving these ports at 9600 baud only.
See the Serial port parameters SIS commands on page 69 to configure either port
using an SIS command.
Installing the Software
The Matrix Switchers Control Program and Firmware Loader are available on the Extron
website, www.extron.com. Download and install both programs as follows:
NOTE: Steps 1 through 6, below, are also used to download firmware update packages.
1. Visit the Extron website, www.extron.com, and click the Download tab (see figure 31).
3
1
2
2
— OR
—
5
4
6
Figure 31. Downloading a Software or Firmware Package
2. Click the Software or Firmware link as appropriate to the operation you are performing.
FOX Matrix 3200 and 7200 Switchers • Matrix Software 72