Filter
Top Products
Using Presets
The current configuration (configuration 0) can be saved as a preset in any one of
32 (FOX Matrix 3200) or 64 (FOX Matrix 7200) preset memory addresses. Presets can
be saved and recalled from the front panel. The preset locations are assigned to input
buttons 1 through 32 (64). When a preset is retrieved from memory, it becomes the current
configuration.
NOTES:
• Presets cannot be viewed from the front panel unless they are recalled as the
current configuration. Presets can be viewed using the Extron Matrix Switchers
Control Program (see the Presets menu description in the “Matrix Software”
section on page 85).
• The current configuration and all presets are stored in non‑volatile memory. When
power is removed and restored, the current configuration is still active and all
presets are retained.
• When a preset is recalled, it replaces the current configuration, which is lost
unless it is also stored as a preset. The recalled preset overwrites all of the current
configuration ties in favor of the preset configuration ties.
Example 6: Saving a preset
In the following an example, the current configuration is saved as a preset. The example
shows the front panel indications that result from your actions.
1. Clear all selections: Press and release the Esc button.
2. Select Save Preset mode: Press and hold the Preset button for approximately
2 seconds until it blinks.
PRESET
PRESET
1 2 3
17 18 19 32
16
Press and hold the Preset button until it blinks.
2 seconds
All input buttons with assigned presets light.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Lit
(preset assigned)
Unlit
(no preset assigned)
3. Select the preset: Press and release the input button or output button for the desired
preset.
C O N T R O L
PRESET
ENTER
ESCVIEW
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
INPUTS
The Enter button blinks to
indicate the need to save the
preset.
The Preset button continues
to blink.
Press and release the Input 1 button.
The button blinks to indicate that this
preset number is selected but not saved.
FOX Matrix 3200 and 7200 Switchers • Operation 37