Filter
Top Products
USING SETUP MODE
User's Manual5-12
DECIDING WHICH OPTIONS
TO CHANGE
The previous page shows a printout of the printer’s factory default
settings. In this printout, options are listed by functional group:
• Menu 1 settings (MENU1 function)
• Menu 2 settings (MENU2 function)
• Hardware settings (HARDWRE function)
• Print position adjustment settings (ADJUST function)
• Configuration settings (CONFIG function)
• Print head gap adjustment settings (GAP-ADJ function)
Most selectable options only alter print features, such as the typestyle,
and page format. However, some options must be selected correctly
for the printer to work properly with your hardware and software.
For each function, Table 5.2 lists items whose options must be selected
correctly for system and printer accessory compatibility.
Table 5.2 Required Options
Function Item Option
MENU1 EMULATE
The emulation selected on the printer
must be the same as the emulation
selected in your software. If you selected
an emulation when you set up the
printer (Chapter 2), you do not need to
change the EMULATE option unless you
want to change to a different emulation.
The emulation assigned to MENU1 is the
default when you turn the printer on.
See the section MENU1 and MENU2
Items and Options later in this chapter.
MENU2 None
If you use MENU2, the emulation
selected for MENU 2 must be the same as
the emulation selected in your software.
See the section MENU1 and MENU2
Items and Options later in this chapter.