Fujitsu DL9300 Printer User Manual


 
Setup Mode
USING SETUP MODE
User's Manual 5-43
Printing the Self-Test
The SELF-TST function prints test pages to check how the printer
operates independently of your computer. The self-test does not
check the interface between the computer and the printer.
The self-test prints the printer’s firmware version, its resident
emulations, and all of the characters available in the currently selected
character set. If the DPL24C PLUS emulation is selected for MENU1,
the self-test is printed using the settings currently assigned to MENU1.
Procedure
This procedure assumes that you are in setup mode. To print the self-
test, make sure that continuous forms paper is loaded into the printer.
Then proceed as follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on the
page. If the menu is not printed, press the ONLINE button to
print the menu. If you are using the HEX-DUMP function, press
the “” or “” button instead of the ONLINE button to print
the menu. The following <<FUNCTION>> menu is printed:
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT
LIST SELF-TST HEX-DUMP V-ALMNT GAP-ADJ