Fujitsu DL9300 Printer User Manual


 
USING SETUP MODE
User's Manual5-42
USING THE DIAGNOSTIC
FUNCTIONS
1. Enter setup mode.
Press the MICRO button and the MICRO button simultane-
ously until the printer beeps. Wait for the printer to stop printing
and check that the following <<FUNCTION>> menu is printed:
2. Select the DEFAULT function.
Repeatedly press the “” or “” button to position the red
cursor on DEFAULT. Press the FONT button or the MENU
button to select the DEFAULT function. The printer reprints
the <<FUNCTION>> menu. The default values in MENU1
and MENU2 are now reset.
3. Do either of the following:
Select new options for MENU1 or MENU2.
Exit setup mode, saving the factory defaults.
See the section MENU1 and MENU2 Items and Options. To
exit setup mode and save the new defaults, make sure that the
red cursors are positioned on SAVE & END, then press the
MICRO button or the MICRO button.
This section describes how to use the following diagnostic functions:
SELF-TST
HEX-DUMP
V-ALMNT
These functions are used for checking print quality and diagnosing
printer problems. HEX-DUMP also provides useful information for
programmers.
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT
LIST SELF-TST HEX-DUMP V-ALMNT GAP-ADJ