Filter
Top Products
PAPER HANDLING
User's Manual3-22
2. Locate the tractor unit on the mounting pins as shown below.
Gently push the unit and down until it clicks into position.
(Adjust the letter B labeled on the cut sheet feeder to the letter B
labeled on the printer.)
Installing the tractor unit (for rear feeding)
Left side mounting
pin (from rear)
3. Press the PAPER PATH button to select REAR TRACTOR (the
indicator lights).
4. Set the continuous forms.
Go to step 4~9 in the section Loading Continuous Forms (Front
Feed) in this chapter.
5. Install the rear stacker to its upper or lower position.
NOTE
Do not place the rear stacker under the stacker guides of the
printer.
6. Load the continuous forms.
Go to step 10 in the section Loading Continuous Forms (Front
Feed) in this chapter.