Fujitsu DL9300 Printer User Manual


 
SETTING UP
2-8 User's Manual
Setting the Paper Table
Lower the paper table until it is in the horizontal position, as shown in
the figure below.
The paper table has two modes depending on how the printer is used.
(Normal mode)
Normal mode is used for manual feeding of cut sheets from the
paper table and feeding continuous forms from the front or rear
tractor.
The following figure shows the paper table in normal mode.
Tractor unit
(Stack mode)
Stack mode is used when a cut sheet feeder option is attached to
the rear of the printer. To put the paper table from normal
mode to stack mode, proceed as follows:
1. Lift up the paper table and remove the tractor unit.