Fujitsu DL9300 Printer User Manual


 
SETTING UP
2-16 User's Manual
TESTING THE PRINTER
(OFFLINE)
At this point, load paper and run the printer self-test. The self-test
checks printer performance and print quality before you connect the
printer to the computer. Use either single sheets or continuous forms
(see Chapter 3). This section describes the self-test procedure using
single sheets.
Loading Paper for the Self-Test
To print the self-test, use paper wider than 215.9 mm (8.5 inches) and
set the left paper guide all the way to the right to avoid clipping the test
pattern. Standard letter or A4 size paper can be used lengthwise
(portrait mode).
Before loading paper, make sure that the printer is on. Then, proceed
as follows:
1. Press the PAPER PATH button on the control panel to select the
cut sheet mode (the CUT SHEET indicator LED lights).
2. Raise the rear stacker to its up position.
Loading a sheet of paper
Rear stacker