Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
94
After the completion of the settings, click the
button. The message below appears. Click
OK to apply the settings. * Reboot is not required.
Table 3-26 Recorder Setting Items
Item Description Parameter
Recording operation Specify whether to perform
recording operation upon start of the
device.
- Enable
- Disable (Default)
Recorder settings
Recording mode Select the recording mode. - Record until full
- Overwrite (Default)
- Record until start position
Recorded data is destroyed if the device power is turned off during recording. Be sure to stop
recording before turning off the device power.
If the device is started with an unused CF card inserted, the CF card is formatted unconditionally.
If [Stream format] of Output interface settings (Main encoder ethernet) described in Section 3.3.1,
"Setting (Encoder)," is "Standard TS," recording cannot be performed.
The maximum system bit rate to record into CF card is limited up to 14.049 Mbps. Recording to and
reading from the CF card simultaneously is possible if the system bit rate does not exceed 6 Mbps.
Recording and simultaneous streaming using the sub encoder are limited to cases in which [Video
resolution] is "352 x 240," "352 x 288," "176 x 112," or "176 x 144" as described in Sub encoder settings
(Encode) in Section 3.3.1, "Setting (Encoder)."