Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
70
Item Description Parameter
ARP auto update If "Unicast (simplex)" is specified
for [Streaming mode], specify
whether to send ARP at regular
intervals to check the
communication with the streaming
destination.
- Enable (Default)
- Disable
ID control for
unicast
If "Unicast" is specified for
[Streaming mode], specify whether
to check the ID for confirming the
validity of a unicast stream
request.
- Enable
- Disable (Default)
* If "Enable" is selected, the Unicast ID of the
encoder and that of the decoder must be in
agreement to perform streaming.
Unicast ID If "Enable" is selected for [ID
control for unicast], specify the ID
to be used for confirming the
validity of a unicast streaming
request.
Hexadecimal number between 0000 and ffff
FEC
Specify whether to generate FEC
packets.
- Enable (Default)
- Disable
FEC interval Set the insertion interval for
generating an FEC packet.
4 to 24 (Default: 10)
ARQ If "Unicast" is specified for
[Streaming mode], specify whether
to enable the ARQ error correction
method.
- Enable
- Disable (Default)
TOS Set IP packet TOS value. Hexadecimal number between 00 and ff
(Default: 0)
Protocol If "Multicast" or "Unicast
(simplex)" is specified for
[Streaming mode] and "Disable" is
selected for [FEC], specify the IP
transport protocol.
- UDP
- RTP (Default)
* If "UDP" is selected, "Standard TS" is
fixedly selected for [Stream format].
Stream format If "Multicast" or "Unicast
(simplex)" is specified for
[Streaming mode], "Disable" is
selected for [FEC], and "RTP" is
specified for [Protocol], specify
the stream format.
- Standard TS
- Time stamped TS (Default)
Pro-MPEG FEC If "Standard TS" is selected for
[Stream format], specify whether
to generate Pro-MPEG FEC
packets.
- Enable
- Disable (Default)
Pro-MPEG Matrix If "Enable" is selected for
[Pro-MPEG FEC], specify the
generation matrix values for FEC
packets.
A value of [4 to 20] x [4 to 20] can be set.
(Default: 10 x 10)
* N x N values that exceed 100 cannot be set.
Streaming port
Specify the own device port
number used for sending streams.
0, 1024 to 64000 (Default: 0)
* If 0 is set, a port number between 64100 and
65000 is automatically selected.
Output
interface
settings
(Sub
encoder
ethernet
port)
Specify the port number of the
destination device used for sending
streams.
1024 to 64000
(Default: 5000)