Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
71
Item Description Parameter
Unicast request
port
Specify the port number of the own
device used for receiving a unicast
streaming request.
1024 to 64000
(Default: 9900)
ARQ control port Displays the port number of the
own device used for controlling
ARQ.
You cannot specify this item.
* This item is automatically set according to
the [Streaming port] setting.
Pro-MPEG FEC
port
Displays the port number of the
own device used for sending
Pro-MPEG FEC.
You cannot specify this item.
* This item is automatically set according to
the [Streaming port] setting.
IP version Specify the IP version of the IP
stream for streaming.
- IPv4 (default)
- IPv6
Streaming mode Specify the streaming method for
the IP interface.
- Multicast (Default)
- Unicast (simplex) : Specifying streaming
destination
- Unicast : Accepting streaming request
Output
interface
settings (Sub
encoder
ethernet)
Acceptable stream
number
Specify the number of possible
streams.
* The contents that can be set
depend on the [System bit rate]
setting.
* If "Multicast" or "Unicast
(simplex)" is specified for
[Streaming mode], only "1" can be
specified.
1 to 4 (System rate is to 5.750 Mbps)
1 to 3 (System rate is 5.751 to 7.666 Mbps)
1 to 2 (System rate is 7.667 to 11.500 Mbps)
1 (System rate is 11.501 Mbps or higher)
* Default is 1
Streaming
destination IP
address
If "Multicast" or "Unicast
(simplex)" is specified for
[Streaming mode], specify the
destination IP address of the
streaming IP stream.
IP address
(Default: 230.11.3.1)
Setting the following values is inhibited:
[IPv4]
240.0.0.0 to 255.255.255.255 (Class E)
0.0.0.0, 127.0.0.0 to 127.255.255.255
[IPv6]
0::0
ARP auto update If "Unicast (simplex)" is specified
for [Streaming mode], specify
whether to send ARP at regular
intervals to check the
communication with the streaming
destination.
- Enable (Default)
- Disable
ID control for
unicast
If "Unicast" is specified for
[Streaming mode], specify whether
to check the ID for confirming the
validity of a unicast stream
request.
- Enable
- Disable (Default)
* If "Enable" is selected, the Unicast ID of the
encoder and that of the decoder must be in
agreement to perform streaming.
Unicast ID If "Enable" is selected for [ID
control for unicast], specify the ID
to be used for confirming the
validity of a unicast streaming
request.
Hexadecimal number between 0000 and ffff
(Default: 0000)
FEC
Specify whether to generate FEC
packets.
- Enable (Default)
- Disable
FEC interval Set the insertion interval for
generating an FEC packet.
4 to 24 (Default: 10)