Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
31
3.2.4 Basic
* Basic comprises a group of setting items, of which 10 sets can be registered independently by
selecting data numbers as in 3.2.1 Configuration Data
.
You can set or change the settings of the parameters related to the network connection of IP-900
series or the operation mode in which it should operate after power-on. Make the required settings by
referring to Table 3-4 Basic Setting Items
.
IMPORTANT
If you operate IP-900 series with the default IP address, disconnect it from your network. Connect it
to the setting terminal via a hub or directly through a UTP cable. From the setting terminal, set it up to
meet the requirements for your network and then connect it to the network. If you connect it to your
network with the default IP address, an unexpected fault may occur in your network.
Figure 3-8 Basic Information Window