Filter
Top Products
Chapter 3 Web Operation
IP-900 Series
101
Item Description Parameter
ARQ buffering time Specify the wait time in msec for an
ARQ retransmitted packet.
* This will increase the delay by the
time specified here.
0 to 2000 ms
(Default: 300 ms)
Pro-MPEG FEC Specify whether to receive
Pro-MPEG FEC packets to activate
the Pro-MPEG FEC error correction
method.
- Enable
- Disable (Default)
Streaming port Specify the own device port number
used to receive streams.
1024 to 64000
(Default: 5000)
Input
interface
settings
(Decoder
ethernet
port)
Unicast request port Specify the streaming request
source port number (own device) in
unicast streaming mode.
0, or10240 to 64000 (Default: 0)
* If 0 is specified, one of the port
numbers from 32768 to 61000 is
automatically selected.
Specify the streaming request
destination port number in unicast
streaming mode.
1024 to 64000 (Default: 9900)
Encoder address
report port
Specify the own device port number
used to receive an encoder address
report.
1024 to 64000 (Default: 5100
Pro-MPEG FEC port Displays the port number of the
own device used for receiving
Pro-MPEG FEC.
You cannot specify this item.
* This item is automatically set
according to the [Streaming port]
setting.
ARQ control port Displays the port number of the
own device used for controlling
ARQ.
You cannot specify this item.
* This item is automatically set
according to the [Streaming port]
setting.
AV output
settings
(video)
Output format at
startup
Specify the format of the video
output signal to be used after the
device is started or after the decoder
settings are changed.
* When any stream has been
received, a setting conforming to
the input format of the encoder is
used.
- 1080i/59.94
- 1080i/50
- 1080i/60
- 720p/59.94
- 720p/50
- 480i/59.94 (Default)
- 576i/50
Analog video setup
Specify the setup level of the analog
video output signal.
- Enable: 7.5 IRE
- Disable (Default): Same as the pedestal
level
Concealment time Specify the time it takes until the
system recognizes that packets have
not been received.
- 5 to 600 seconds
(Default: 10 seconds)
Display when no data
receiving
Specify the video signal to be output
when no packets are received.
- Blue (Default)
- Gray
Decoder
settings
(Decode)
Decoding operation Specify whether to enable receiving
and decoding streaming video upon
starting.
- Enable.
- Disable. (Default)
Error concealment Specify whether to enable the freeze
control that prevents block noise in
the event of packet loss.
- Enable (Default)
- Disable